Getting the valve geometry correct...

Rocker blocks too high for correct geometry, as such embarked on some milling following buying a basic slide for the lathe.

First step machining some bolts to mount the slide:

Then set the slide and trued it to bed.

Blocks then mounted in pairs within the vice to ensure matched sets, and took gradual horizontal cuts with the mill bit. 

Third block simply to match height to other pair. 

Worked well with some hand finishing needed:

Blocks in situ during measurement, adjustable pushrod in place. 

Next job: cutting pushrods to length!

Radial engine built out of VW air cooled

Carbs installed

Carbs installed and connected up to AN hoses, had quite a job getting the correct fitting for IDF as a number of variations in production, and still required machining to fit but does make removal a doddle. 

Also installed heat isolating plates and the correct gaskets between manifold and carb. 

All hooked up to a Holley T pressure junction and gauge so the required 3.5psi can be accurately dialed in.

New Venturi 34mm down from 36mm

After a long absence of car work, got distracted by new motorbike, now back at it and engine back in car + some carb refurbishment and improvement. 

New Venturi purchased from eurocarb_ltd, installed and finished off with locating detent. 

As installed, a small job but worth it.

Insitu 

New gaskets and pump diaphragm as modern fuels aren't kind!

New toy!

It's been a while but finally making some renewed progress

Motorbikes and cycling France top to bottom has taken away from the garage time, however back on track hopefully!

Trim going back on and windows going back in.

Noticed some scratches in the glass but should polish out ok, it's the original glass but think they might have got damaged in storage. 

I did notice the packaging label on the trim box which has 2008 on it, which shows just how long the project is taking!

Have made a commitment to get back on the road for next year- might even have it ready for a drive down to Volksworld 

The sister blog...

http://www.l2p-jogle.blogspot.co.uk

This years round of madness is in France for a little jaunt down to the med, you can follow our progress on the blog